Albums: 3D Fun

3D Fun

3D Fun

11 images

Pages

Resting skeleton

This guy was fun but a bit hard to print. The support structures were difficult but with Simplify3D I was able to get it close. I will not do any interior support next time, though. It's just too hard to remove from some of the internal cavities. The joints were VERY hard to get together. I ended up sanding and filing the knobs quite a bit and it's still pretty tight. But that also means he will stay where you put him which is good. This was collected from https://www.thingiverse.com/thing:1846865
Uploaded by admin on Sun, 10/01/2017 - 00:32 194 visits Add new comment

Rocket ship

This fits over the straw on a can of canned air (duster). If you add some water to the rocket first it will go quite high.
Uploaded by Bill Waggoner on Sun, 10/01/2017 - 00:32 508 visits 2 comments

Rocket ship

On the build platform
Uploaded by Bill Waggoner on Sun, 10/01/2017 - 00:32 520 visits Add new comment

Flat skeleton

Uploaded by Bill Waggoner on Sun, 10/01/2017 - 00:32 1857 visits 9 comments

Grimm

Just in time for halloween ... 💀
Uploaded by Bill Waggoner on Sun, 10/01/2017 - 00:32 247 visits Add new comment

Loaded catapults

I found that jelly beans make great ammo!
Uploaded by Bill Waggoner on Sun, 10/01/2017 - 00:32 186 visits Add new comment

Catapults

These are printed in one piece from PETG. They are very effective!
Uploaded by Bill Waggoner on Sun, 10/01/2017 - 00:32 499 visits 2 comments

Benchy

This is 3-D Benchy a test print from http://3dhubs.com. You can view my hub page at https://www.3dhubs.com/bridgeport/hubs/greybeard
Uploaded by Bill Waggoner on Sun, 10/01/2017 - 00:32 249 visits Add new comment

A collection

Just a collection of things I've made
Uploaded by Bill Waggoner on Sun, 10/01/2017 - 00:32 440 visits Add new comment

Gears

These gears are also printed together at one time and rotate freely. They cannot be separated.
Uploaded by Bill Waggoner on Sun, 10/01/2017 - 00:32 374 visits 2 comments

Pages